Intel BOXD865PCDL Datenblatt PDF herunterladen (Seite 26)

Intel Desktop Board D865PCD Technical Product Specification

1.6.3 IDE Support

The board provides two Parallel ATA IDE connectors, which support a total of four devices (two

per connector). The ICH5’s Parallel ATA IDE controller has two independent bus-mastering

Parallel ATA IDE interfaces that can be independently enabled. The Parallel ATA IDE interfaces

support the following modes:

• Programmed I/O (PIO): processor controls data transfer.

• 8237-style DMA: DMA offloads the processor, supporting transfer rates of up to 16 MB/sec.

• Ultra DMA: DMA protocol on IDE bus supporting host and target throttling and transfer rates

of up to 33 MB/sec.

• ATA-66: DMA protocol on IDE bus supporting host and target throttling and transfer rates of

up to 66 MB/sec. ATA-66 protocol is similar to Ultra DMA and is device driver compatible.

• ATA-100: DMA protocol on IDE bus allows host and target throttling. The ICH5’s ATA-100

logic can achieve read transfer rates up to 100 MB/sec and write transfer rates up to 88 MB/sec.

✏ NOTE

ATA-66 and ATA-100 are faster timings and require a specialized cable to reduce reflections,

noise, and inductive coupling.

The Parallel ATA IDE interfaces also support ATAPI devices (such as CD-ROM drives) and ATA

devices using the transfer modes listed in Section 4.4.4.1 on page 86.

The BIOS supports Logical Block Addressing (LBA) and Extended Cylinder Head Sector (ECHS)

translation modes. The drive reports the transfer rate and translation mode to the BIOS.

The board supports Laser Servo (LS-120) diskette technology through the Parallel ATA IDE

interfaces. An LS-120 drive can be configured as a boot device by setting the BIOS Setup

program’s Boot menu to one of the following:

• ARMD-FDD (ATAPI removable media device – floppy disk drive)

• ARMD-HDD (ATAPI removable media device – hard disk drive)

For information about Refer to

The location of the Parallel ATA IDE connectors Figure 11, page 51

1.6.4 Real-Time Clock, CMOS SRAM, and Battery

A coin-cell battery (CR2032) powers the real-time clock and CMOS memory. When the computer

is not plugged into a wall socket, the battery has an estimated life of three years. When the

computer is plugged in, the standby current from the power supply extends the life of the battery.

The clock is accurate to ± 13 minutes/year at 25 ºC with 3.3 VSB applied.

✏ NOTE

If the battery and AC power fail, custom defaults, if previously saved, will be loaded into CMOS

RAM at power-on.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 109 110

Keine Kommentare

Intel BOXD865PCDL Datenblatt Seite 26